This rep
Clip
Shoot it in Slo-Mo, landscape, one throw per clip. The Help tab has the full setup.
Camera setups
One setup per camera position. It stores how many pixels make a foot at the distance the ball actually travels. Move the tripod and you need a new one.
Session
Reps
Check against the gun
Gun a session while you film it. Type each radar reading next to the rep it belongs to. Once there are 20 pairs this tab will tell you what the camera is actually worth — the bias it carries and the spread around it. Nothing here leaves this app.
Paired readings
Shooting a clip
- Landscape, on a tripod. The app reads gravity out of the ball's arc to check itself, and that only works if the phone is level and still.
- Stand square to the throw. The camera looks at the throwing lane from the side, at ninety degrees. Any angle off square reads low, the same way a gun does.
- Frame the first 15–20 feet after release — not the whole flight. That is the window a radar gun reports, and framing tight keeps the ball big in the picture. For a bullpen this means standing beside the mound, not behind the plate.
- Slo-Mo, not Video. 240 fps if the phone offers it.
- One throw per clip, and trim it close. Long clips get slow and can run the iPad out of memory.
Setting the markers
- Put two cones on the floor directly underneath the throwing lane, and measure between them with a tape. Ten feet is plenty.
- Underneath matters more than it sounds. What the app needs is two points the same distance from the lens as the ball. A cone off to the side is nearer or further, and every reading inherits that error.
- Mark the lane itself too — a chalk line or a second pair of cones. A throw that drifts a foot toward the camera reads about 5 mph fast, and nothing in the clip can tell you it happened.
What the numbers mean
What this app is not
It is not a radar gun and it has not been checked against yours. It writes nothing into Velo Tracker or Hitter Tracker — reps live here and here only, and you can lift them out as a CSV. It reads the shared roster so you do not retype names, and it never writes to it. Until the Check tab says otherwise, treat every number on this screen as a candidate, not a record.